|
|
|
Features
- Choice
of three material hold-down systems
Three material hold-down systems are available
for the FC2230 series; 1) Magnetic hold-down system
provided on the MG models is the economical option
for processing relatively thin and rigid material as
material is held along the outer edges. 2) Electrostatic
hold-down system provided on the ES models is the versatile
and intermediate choice when relatively flexible sheets
are included in the target material as it holds the
entire material surface by static electricity. 3) Vacuum
hold-down system found on the VC models is the ultimate
option for processing thick and heavy material such
as corrugated cardboard, card stock, or PVC sheet up
to approximately 40mils.
|
- High-speed
and precision digital servo drive system
The precision digital servo system incorporated in
the FC2230 series delivers the top cutting speed of
12"/sec (300mm/sec), 0.0001" (0.0025mm) mechanical
resolution, and 0.004" (0.1 mm) repeatability accuracy,
ensuring smooth and accurate cutting/plotting of designs
on a variety of material.
|
- Four user settings for productivity and versatility
User friendly control panel with a LCD display window
provides intuitive setup and operation. Up to four
application-specific user settings can be programmed
via control panel for instantaneous recall and setup
execution. The type of cutting blade/pen, cutting offset
value, cutting/plotting speed, cutting pressure, and
quality can be independently programmed in each of
four user settings depending on the type of material
and design. Once the desired user settings have been
programmed, the on-board, non-volatile memory will
maintain those settings, until they are reprogrammed,
for single-key-stroke selection, thus minimizing setup
time to enhance job productivity and flexibility
|
- A
variety of system configurations to suit a broad
range of application needs
The two pen/blade models (FC2232-) hold a cutting blade
and a plotting pen simultaneously allowing the user
to toggle between plotting (drawing) and cutting operation
remotely. The FC2232 models are suitable for applications
where both cutting and plotting operations are frequently
required, such as plotting marking lines and cutting
the marked material in garment pattern production.
The FC2232 also benefits such applications that require
test plotting on paper prior to cutting the valuable
material for verification of designs for minimizing
production cost. and accuracy The single pen/blade
models (FC2231-) are an economical choice for applications
where manual exchange of tools (cutting blade or plotting
pen) is acceptable.
Choice of maximum cutting force, 500g for the
standard -N models and 1000g for the optional -T
models, further broaden the compatibility of
the FC2230 series with a variety of production
needs.
A broad range of cutting blades and compatible
blade holder accessories are optionally available
to accommodate the variety of material being
processed.
The FC2230 series is available with four cutting
area sizes measuring:
| FC2231-60 FC2232-60
models |
36.2" x 24.0"
(920mm x 610mm) |
| FC2231-90 and FC2232-90
models |
36.2" x 47.2"
(920mm x 1200mm) |
| FC2231-90EX models |
36.2" x 70.9"
(920mm x 1800mm) |
| FC2232-90EX models |
36.2" x 68.5"
(920mm x 1740mm) |
|
|
|
|
