Telephone - 0845 130 5565
Email Us 
|
|
Using a water-based
coating, the Uniform WetGUARD is perfect for protecting wide
format inkjet prints including signage printed on water-resistant
media, vehicle graphics, fine art reprints on water-resistant
canvas and more. |
||
| The
Uniform WetGUARD provides UV, water and abrasion protection.
It also enhances the vibrancy of the inks. The cost to protect your prints is considerably lower that using film laminates, and the media retains it's flexibility. The primary reason for buying a Uniform WetGUARD is the ease of use. You can quickly apply a consistent protective coating to your printed output, and elimate the mess and wastage associated with hand application. WetGUARD takes only a minute to set up, seconds to coat, and just a few minutes to clean following use. |
|||
The Uniform WetGUARD is the easiest, most effective way to apply a protective top coat to your prints...
Pour coating into the tray. (Braces secure the applicator to the table). |
Swivel the coating rod up and insert your media over the tray. |
Swivel the coating rod down and the media is submerged in the coating. |
Pull the media through the unit. |
As you pull the media through, the coating rod wipes off a portion of the coating, leaving a smooth even finish. The red wiper, below the media, completely wipes off the coating from the back, leaving it perfectly dry. |
When finished, drain the coating back into the bottle and wipe down the coating rod with water. |
That, in a nutshell is the Uniform WetGUARD. The question is, at only £695, can you afford not to have one?
 Follow us on Facebook |
|
